This is a working overview of lyophilized powder, written for readers who want more than a one-paragraph summary but less than a textbook.
This page was last updated on 2025-08-15 and is reviewed periodically as new material appears.
Melanotan-2 is handled in the laboratory as a lyophilised powder that dissolves readily in water, dimethyl sulfoxide and dimethylformamide, with limited solubility in ethanol. Stock solutions prepared in an organic solvent often precipitate when diluted into aqueous buffer, so gradual dilution with mixing is standard practice. The peptide carries a tryptophan residue and a histidine residue, both sensitive to oxidation and to alkaline conditions. Working solutions are therefore kept near neutral to slightly acidic pH, protected from light, and consumed within the same working session whenever that is practical.
Solid peptide kept dry at minus twenty degrees Celsius, shielded from light and moisture, is generally considered stable for extended periods. Solutions are divided into single-use aliquots and held at minus twenty or minus eighty degrees Celsius, because repeated freeze-thaw cycles promote aggregation and loss of material to container surfaces. Hydrolysis of the backbone and oxidation of tryptophan are the principal degradation routes in aqueous solution, and both accelerate at ambient temperature. Hygroscopic uptake after a vial is opened can also shift the actual mass weighed, which affects any concentration calculated from it.
Routine characterisation relies on reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres, using a C18 column and a water-acetonitrile gradient containing trifluoroacetic acid. Electrospray ionisation mass spectrometry confirms the expected molecular mass and can reveal truncated or oxidised by-products that co-elute poorly. Sequence and stereochemistry require additional work, such as peptide mapping or amino acid analysis, because a chromatographic purity figure alone does not distinguish a diastereomer from the target peptide. Independent testing of research-grade material frequently shows measured content below the stated label, so a certificate of analysis is best read together with the method that produced it.
The compound emerged from research programs in the 1980s that examined analogues of alpha-melanocyte-stimulating hormone for pigmentation and photoprotection. Investigators modified the native sequence to extend activity duration and potency. A related analogue, afamelanotide, was developed within the same broad line of inquiry and eventually gained approval in certain jurisdictions for a rare light-sensitivity condition. Melanotan-2 itself did not progress through the same regulatory route and has no approved therapeutic indication.
Melanocortin receptors comprise five subtypes with distinct tissue distributions and functions. Melanotan-2 is described in the literature as a non-selective agonist that engages several of these subtypes, including MC1R, MC3R, MC4R, and MC5R. MC1R is the subtype most directly linked to melanin production in skin cells. Because the compound is not subtype-selective, its observed effects in experimental settings are generally attributed to activity across multiple receptor pathways rather than to a single target.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilised material may be hygroscopic |
| Solubility class | Soluble in water, DMSO and DMF | Dilution into aqueous buffer can cause precipitation |
| Storage of solid | Minus 20 degrees C, desiccated, dark | Aliquot to limit repeated opening of the vial |
| Storage of solution | Minus 20 to minus 80 degrees C, aliquoted | Avoid repeated freeze-thaw cycles |
| Identity method | Reversed-phase HPLC with mass spectrometry | Retention time and mass are checked together |
The material is commonly handled as a lyophilized powder in sealed vials. The solid dissolves readily in water and in polar organic solvents, producing a clear solution after reconstitution. Light, heat and repeated freeze-thaw cycles are the concerns most often raised in handling guidance, because peptide bonds and the constrained ring can degrade. Working solutions are generally prepared fresh, and material left in solution is treated as less stable than the dry form. These properties shape how laboratories store and aliquot reference material.
Identity and purity are assessed mainly by reversed-phase high-performance liquid chromatography with ultraviolet detection, often paired with mass spectrometry. Retention time supports identity, while the mass spectrum confirms the molecular weight of the intact peptide. Purity is frequently reported as a percentage of total peak area, a figure that depends on the wavelength, column and gradient used. Impurity profiling may also look for truncated sequences, oxidised forms and residual counterions. Amino acid analysis and peptide mapping provide orthogonal confirmation when required.
Regulatory status varies by jurisdiction, and the substance is frequently described as unapproved for therapeutic use. Some authorities classify it alongside prescription-only medicines or controlled categories, while others address it through general consumer protection rules. Analytical surveys have reported mismatches between label claims and measured content in products sold online, although the scope of such testing is limited. Whether these discrepancies are widespread remains an open question. Discussion in the literature therefore tends to combine chemistry, supply-chain observation and policy analysis.
Melanotan-2 is a synthetic peptide designed as an analog of alpha-melanocyte-stimulating hormone, a signaling molecule produced in the pituitary and skin. Its structure is a linear chain of seven amino acids that folds into a ring through an internal lactam bridge joining two side chains. The compound is sometimes written as MT-II or MEL-2 in informal and commercial contexts. It belongs to the melanocortin peptide family, a group of short signaling molecules that share a conserved core sequence recognized by melanocortin receptors.
Two structural changes distinguish the synthetic peptide from the natural hormone. A norleucine residue replaces methionine at one position, and a D-configured phenylalanine replaces the natural L-form at another. Both substitutions slow enzymatic breakdown, which extends the molecule's persistence relative to the parent hormone. The lactam bridge further constrains the backbone into a stable conformation. These features are standard design strategies in peptide chemistry and are not unique to this compound; they appear across many research peptides built for improved stability.
The compound was developed in the late 1980s and early 1990s by academic researchers investigating melanocortin signaling and pigmentation. Early work explored whether synthetic analogs could reproduce effects of the natural hormone under controlled conditions. The molecule never advanced through the full regulatory pathway required for approval as a medicine. From the mid-2000s onward it appeared in unregulated consumer markets, often distributed through informal channels. That gap between research origins and commercial availability shapes how the compound is discussed today.
Handling guidance for melanotan II follows general practice for small synthetic peptides rather than a product-specific monograph. Lyophilized powder is typically kept at minus twenty degrees Celsius or colder, protected from light and moisture, because warmth and humidity accelerate degradation. Once reconstituted, solutions are usually refrigerated and used within a short window, as hydrolysis and microbial growth both become concerns. Repeated freeze-thaw cycles are generally avoided. These conventions come from laboratory peptide chemistry and not from formal stability studies on this specific compound.
Analytical confirmation of identity relies on mass spectrometry, most often coupled to liquid chromatography. Reversed-phase high-performance liquid chromatography separates the peptide from related impurities and provides a purity estimate based on peak area. Electrospray ionization mass spectrometry then confirms the expected molecular mass, while tandem mass spectrometry can map the fragment sequence. For research-grade material, these two techniques together form the standard minimum. Purity figures reported by vendors are frequently not traceable to an independent laboratory.
Duane Tolbert Gish (February 17, 1921 – March 5, 2013) was an American biochemist and a prominent member of the creationist movement. A young Earth creationist, Gish was a former vice-president of the Institute for Creation Research (ICR) and the author of numerous publications about creation science. Gish was called "creationism's T. H. Huxley" for the way he "relished the confrontations" of formal debates with prominent evolutionary biologists, usually held on university campuses, while abandoning formal debating principles, in a style that came to be known as the Gish gallop. A creationist publication noted in his obituary that "it was perhaps his personal presentation that carried the day. In short, the audiences liked him."
Emoxypine (2-ethyl-6-methyl-3-hydroxypyridine), also known as Mexidol or Mexifin, a succinate salt, is chemical compound which is claimed by its manufacturer, the Russian company Pharmasoft Pharmaceuticals, to have antioxidant and actoprotector properties, but these purported properties of emoxypine have not been proven. Its chemical structure resembles that of pyridoxine (a type of vitamin B6).
=== Algeria === Algeria is an oil and natural gas producer, and one of the European Union's largest suppliers of LNG. It has entered talks with Spain and Italy, as well as fielding enquiries from other countries, including Vietnam. It could benefit economically.
Ileus is a disruption of the normal propulsive ability of the intestine. It can be caused by lack of peristalsis or by mechanical obstruction. The word 'ileus' derives from Ancient Greek εἰλεός (eileós) 'intestinal obstruction'. The term 'subileus' refers to a partial obstruction.
Sources: en.wikipedia.org
=== Applications === The triple-stranded DNA regions can be generated through the association of Triplex Forming Oligonucleotides (TFO) and Peptide Nucleic Acids (PNAs). Historically, TFO binding has been shown to inhibit transcription, replication, and protein binding to DNA. TFOs tethered to mutagens have also been shown to promote DNA damage and induce mutagenesis. Although TFO have been known to hinder transcription and replication of DNA, recent studies have shown that TFO can be utilized to mediate site specific gene modifications both in vitro and in vivo. Another recent study has also shown that TFOs can be used for suppression of oncogenes and proto-oncogenes to reduce cancer cell growth. For example, a recent study has used TFOs to reduce cellular death in hepatoma cells through the decreasing the expression of MET. PNA TFOs have the ability to enhance recombination frequencies, leading to targeted, specific editing of genes. The PNA-DNA-PNA triplex helix is able to be recognized by the cell's own DNA repair mechanism, which sensitizes the surrounding DNA for homologous recombination. In order for a site-specific PNA structure to mediate recombination within a DNA sequence, a bis-PNA structure can be coupled with a 40nt DNA fragment that is homologous to an adjacent region on the target gene. The linking of a TFO to a donor DNA strand has been shown to induce recombination of the targeted gene and the adjacent gene target region.
Ohnologous genes are paralogous genes that have originated by a process of whole-genome duplication. The name was first given in honour of Susumu Ohno by Ken Wolfe. Ohnologues are useful for evolutionary analysis because all ohnologues in a genome have been diverging for the same length of time (since their common origin in the whole genome duplication). Ohnologues are also known to show greater association with cancers, dominant genetic disorders, and pathogenic copy number variations.
The modifications covered in this diagram have to do with carbon skeleton modifications of the original fentanyl molecular structure. These are organized into methyl acetate additions, which are most known for the fentanyl -> carfentanil conversion. Many analogues of great potency, such as ohmfentanyl and lofentanyl possess methyl acetate groups added to the 4-carbon (of the piperidine ring, in the para- position relative to the annular nitrogen). The methyl acetate is added here from the α-carbon of the acetate moiety as it is with ohm- and lofentanyl. The 4-carbon is not a chiral center in carfetnanil because of a lack of piperidinyl substituents, but this same carbon is a chiral center in both ohm- and lofentanyl because both of those analogues have piperidinyl substituents. The second group are organized into methyl additions, which are known for the fentanyl analogues such as α-methylfentanyl and cis-3-methylfentanyl. These analogues can possess a wide variety of modified pharmacological properties, including increased and decreased potency (receptor binding efficiency), increased or decreased half-life (metabolic binding efficiency) or other side effects on human physiology. Other substituents such as hydroxy, chloro, fluoro, and a wide variety of alkyl groups, are also substituted in place of these methylations to produce psychoactive analogues of fentanyl, but because they often use the same skeletal naming conventions as the simple methyl analogues, we did not reproduce them all in the image here.
Sources: en.wikipedia.org
Purity is normally stated as an area percentage from high-performance liquid chromatography, for example ninety-five or ninety-eight percent. That figure describes the proportion of ultraviolet-absorbing material eluting as the main peak. It says nothing about water content, counterions, residual solvents or mass fraction of the peptide itself.
Peptides are commonly isolated as acetate or trifluoroacetate salts, and the counterion contributes to total mass. Two vials with identical peptide content can therefore differ in weight and in measured response. Residual trifluoroacetate is also relevant in cell-based work because it can influence membrane behaviour.
Degradation products are often closely related to the parent molecule, making them hard to resolve with a single method. Counterion variability adds a further source of scatter between laboratories. Because no pharmacopoeial monograph exists for melanotan-2, groups rely on method-specific validation rather than a shared reference standard.
No. Melanotan-2 is manufactured synthetically. The naturally occurring peptide in the same family is alpha-melanocyte-stimulating hormone, which the body produces as part of normal endocrine and neural signalling.